A tile has to come back to the cut it started with for the clip to
loop, so every tile swapped at least twice a clip, and below that
rounding left every tile still: the bottom of the slider was either
frozen or busy. Swap rate is now the average per tile: below two swaps
a clip only a share of the tiles swap (twice each), fewer the lower it
goes, and above it each tile rounds up or down by its own draw.
ParamSpec::slider() takes an optional curve: the scale runs over the
slider's travel and sliderValue/sliderPosition map it onto the number
as position^curve. Swap rate uses a curve of 3, so the low end gets
most of the slider; the command line and project file are unchanged.
Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
